1.0 link Rainbow Dash Network http://rainbowdash.net/ adiwan (adiwan) http://rainbowdash.net/adiwan http://rainbowdash.net/notice/5482531 I bought a tool for splicing 3d printer filament. It's difficult as hell. I bought it so I can use up all those "too much to throw away but too short to print anything usable" spools. The main problem is that I end up having a splice that is way too thick to fit through the PTFE tube that will definitely end up as a print failure. At this point I think it is a operator failure than a failure of the tool. I give it more tries until I throw it into the corner.